Schumacher SS-210A Manuel d'utilisateur télécharger pdf (Page 4)

L. LED DISPLAY

Red blinking (slow) – indicates check battery connection or

blown fuse

Red blinking (fast) – indicates error, abort stage

Red solid – charger is charging, current at maximum

Yellow #1 solid – charger is charging, voltage >14.2 volts

Yellow #1 blinking – desulfation mode

Yellow #2 solid – charger is charging, constant voltage

Green solid – charger is in final 3-hour charge.

95% charged

Green blinking – charge complete maintain stage

M. AUTOMATIC CHARGE MODE

The automatic charger uses a three-step charging process. During the BULK charge phase, the charger attempts to deliver 10/(20) amps

of current to the battery(ies) until the battery voltage levels off. At this point, the charger enters the ABSORPTION charge phase. In this

phase, the charger will hold the battery voltage constant and let the battery determine the charging current. When the charging current

stabilizes, the charger will continue to charge for three hours to bring the battery up to full charge. The charger will then automatically

enter the MAINTAIN MODE. During this phase, the charger will hold the battery voltage constant at 13.2 volts to guard against self-

discharge of the battery. The charge current will typically be a few tenths of an amp.

If the battery has been left discharged for an extended period of time, it may have become ‘SULFATED’. If the battery voltage is less than

12.2 volts prior to being charged, and the voltage climbs rapidly when charging begins, the battery may be SULFATED. Under this

condition, the charger enters DESULFATION MODE; this is indicated by the first YELLOW LED blinking. In DESULFATION MODE, the

initial charging current is very small. The charger will stay in DESULFATION MODE for up to 24 hours, attempting to break down the

sulfation. If the battery current increases to normal in this time, the charger will enter the normal AUTOMATIC MODE. If the current does

NOT increase to normal, the charger will enter the ABORT state and will shut off. The rapid flashing of the RED LED indicates the ABORT

state and the battery may need to be replaced. The charger will remain in abort until the AC power is removed.

N. DESULFATION MODE

O. EXTENDED BATTERY STORAGE

The charger will draw a small amount of current from the battery(ies), a few milliamps, when not charging or maintaining. If the

battery(ies) are going to be stored for an extended period of time (several months) without being charged, it is best to disconnect the

leads or remove the fuse to keep the charger from discharging the battery(ies) over time.

P. MAINTENANCE / CLEANING INSTRUCTIONS

Very little maintenance is required for the battery charger. Use common sense in wiping the charger clean and store in a clean, dry area.

1. After use, use a dry cloth to wipe all battery corrosion and

other dirt or oil from terminals, cords, and the charger case.

2. Coil charger cords to prevent damage.

3. Have any cracked or frayed cords replaced by a qualified

professional.

4. Store battery charger in a clean, dry area.

NOTE:

When both output leads are connected to one battery,

only channel one will display the charge status of the battery.

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, ILLINOIS 60056-2179 MAKES THIS LIMITED

WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE.

Schumacher Electric Corporation warrants this battery charger for two years from date of purchase at retail against defective material or workmanship. If

such should occur, the unit will be repaired or replaced at the option of the manufacturer. It is the obligation of the purchaser to forward the unit together with

proof of purchase, transportation and/or mailing charges prepaid to the manufacturer or its authorized representative.

This limited warranty is void if the product is misused, subjected to careless handling, or repaired by anyone other than the manufacturer or its authorized

representative.

The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including any warranty for consequential

damages.

THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME

OR MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY. THE MANUFACTURER

MAKES NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS PRODUCT AND EXPRESSLY EXCLUDES SUCH FROM

THIS LIMITED WARRANTY.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LENGTH OF IMPLIED

WARRANTY SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE.

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Schumacher SS-210A Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Schumacher SS-210A