Schumacher PID-410 Manuel du propriétaire télécharger pdf (Page 6)

• 6 •

the  displays after several attempts, there is a short circuit or the device requires

more “starting” or “peak” load than the inverter is capable of providing.

If you are using the power inverter to operate a battery charger,

monitor the temperature of the battery charger for about 10 minutes. If the battery

charger becomes abnormally warm, disconnect it from the inverter immediately.

NOTE: You can use an extension cord from the inverter to the device without

signicantly decreasing the power being generated by the inverter. For best

operating results, the extension cord should be no longer than 50 feet.

Using the USB Port

The USB port provides up to 2A at 5V DC.

1. Plug the device into the USB port.

2. Press and hold the ON/OFF switch to turn the inverter on. (The internal

speaker will make a brief “beep”. This is normal.).

3. Turn the USB device on.

4. Reverse these steps when nished using the USB port.

Using the Inverter to Operate a TV or Audio Device:

The inverter is shielded and ltered to minimize signal interference. Despite this,

some interference may occur with your television picture, especially with weak

signals. Below are some suggestions to try and improve reception.

1. Make sure the television antenna produces a clear signal under normal operating

conditions (i.e. at home plugged into a standard 120V AC wall outlet). Also,

ensure that the antenna cable is adequately shielded and of good quality.

2. Try altering the position of the inverter, antenna cables, and television power

cord. Add an extension cord from the inverter to the TV so as to isolate its

power cord and antenna cables from the 12V power source.

3. Try coiling the television power cord and the input cables running from the 12V

power source to the inverter.

4. Afx one or several “Ferrite Data Line Filters” to the television power cord.

Ferrite Data Line Filters can be purchased at most electronic supply stores.

NOTE: You may hear a “buzzing” sound being emitted from inexpensive sound

systems when operated with the inverter. This is due to ineffective lters in the

sound system’s power supply. Unfortunately, this problem can only be resolved by

purchasing a sound system with a higher quality power supply or higher quality lter.

6. POWER SOURCE

Your average automobile or marine battery at full charge will provide an ample power

supply to the inverter for approximately 3 hours when the engine is off. The actual

length of time the inverter will function depends on the age and condition of the battery

and the power demand being placed by the device being operated with the inverter.

If you decide to use the inverter while the engine is off, we recommend you turn

OFF the device plugged into the inverter before starting the engine. To maintain

battery power, start the engine every 2 to 3 hours and let it run for approximately

10 minutes to recharge the battery.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Schumacher PID-410 Manuel du propriétaire Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Adaptateurs et onduleurs de puissance Schumacher PID-410