Schumacher PI-1500 Spécifications

00-99-000628/0206OWNER'S MA NUA L1500 Watt DC to AC Power InverterConver t s 1 2 V D C B a t t e r y Power to 110V AC Home Power– SAVE THES

- 9 -Using GFCI OutletThe GFCI (Ground Fault Interrupter) must be tested before each use. To test:1. Turn the inverter ON.2. Push the "RESET&q

- 10 -inverter to reset. To reset: press the “TEST” button (stops ow of electricity to outlet) on the outlet face. Next, press the “RESET” button (re

- 11 -power consumption. When the inverter is OFF, no lights appear.Using the Inverter to Operate a TV or Audio DeviceThe inverter is shielded and lt

- 12 -Blown FuseA blown fuse is usually caused by reverse polarity or a short circuit within the device or equipment being operated. If the fuse blows

- 13 -Safety FeaturesThe LED Indicator light will turn from GREEN to RED and the inverter will automatically turn itself off when:1. The power input

- 14 -STAGE 2: The inverter then converts the 145-volts DC into 110-volts AC (household voltage) using advanced MOSFET transistors in a full bridge co

- 15 -PROBLEM: Audible Alarm On All The TimeReason/Solution1. Input voltage below 11 volts. Recharge or replace battery to maintain adequate power

- 16 -SPECIFICATIONS:Maximum Continuous Power ... 1500 wattsSurge Capability (Peak Power) ... 3000 Watts

- 17 -Schumacher Electric Corporation, Warranty Service Department1025 Thompson, Hoopeston, IL 60942Phone: 800-621-5485 (Hours: 7 a.m. - 4:30 p.m. C

- 1 -The advanced surge capacity of the PI-1500 power inverter gives it the means to start most electrical devices including: color televisions, TV/VC

- 2 -• Do not place the inverter in direct sunlight. The ideal air temperature for operation is between 30º and 105ºF.• Keep the inverter well venti

- 3 -• If you are powering the inverter with an automobile or ma-rine battery, start the engine every 30 to 45 minutes and let it run for about 10 mi

- 4 -In the event of a power overload, the inverter is designed to automatically shut down. This safety feature prevents damaging the inverter while t

- 5 -2. Place the back of the PI-1500 with the mounting bracket against a secure and at surface.3. Attach the inverter to the at surface us

- 6 -Grounding the PI-1500To avoid electrical shock, it is necessary to ground the PI-1500 Inverter as well as the device powering it. The inverter sh

- 7 -Connecting Inverter CablesThe inverter and the power source must be in the OFF mode.Inverter Connection:1. Locate the positive and negative

- 8 -Connecting Your PI-1500To Turn ON:1. Push the rocker switch, located on the right side, to the “ON” (I) position. The LED indicator light s