Schumacher PI-400 Manuel d'utilisateur Page 1

00-99-000346/0805

 Make sure the power consumption of the appliance or equipment you want to operate is compatible with the capacity of the inverter, i.e.

PROBLEM: Red LED OnReason/Solution1. Battery voltage below 11 volts. Recharge or replace battery. 2. Equipment being operated is drawing too much

SPECIFICATIONS:Maximum Continuous Power ...………………...400 WattsSurge Capability (Peak Power)………………… 800 WattsNo Load Current Draw ...………………….

Schumacher Electric Corporation, Warranty Service Department1025 Thompson, Hoopeston, IL 60942Phone: 800-621-5485 (Hours: 7 a.m. - 4:30 p.m. CST)You

The advanced surge capacity of the PI-400 power invert-er gives it the means to start most electrical appliances including: Color televisions, TV/VCR

To calculate the starting load: Starting Load = 2 x WATTS. In general, the start up load of the appliance or power tool determines whether your inve

 Incorrect operation of your inverter may result in damage and personal injury. Electrical current on a 110-volt circuit can be very dang

You can use an extension cord from the inverter to the appliance without significantly decreasing the power being generated by the inverter. For best

Affix one or several "Ferrite Data Line Filters" to the tele-vision power cord. Ferrite Data Line Filters can be pur-chased at most electron

Power SourceYour average automobile or marine battery will provide an ample power supply to the inverter for 30 to 45 minutes even when the engine is

2. The power input from the battery exceeds 15 volts. 3. The continuous load demand from the equipment or appliance being operated exce

 While in use, make sure there are several inches of clearance around the top and sides of the inverter.  Do not use the inverter near infla